Flashing the easy way – The Gosund SP111 adapter

I have installed many of these sockets in my Smarthome. Of course I don’t want to run them with a Chinese firmware. So I need Tasmota to come in… But soldering pins into each socket to flash is way too much work. So I developed this adapter that makes the process very simple.

You can download it here.
You can find the connectors that I used at Conrad.

Do not forget: If you own the new version of the sockets, please adapt the template from Tasmota:

{"NAME":"Gosund SP111 v2","GPIO":[56,0,57,0,132,134,0,0,131,17,0,21,0],"FLAG":0,"BASE":18}

To configure voltage, amp etc, use this codes directly from the Tasmota console:

VoltageSet 230  //set to 230 volt
PowerSet 60 //calibrate watt
TelePeriod 10 // Send data every 10 seconds

Share

You may also like...

6 Responses

  1. Meier says:

    Hallo!

    Schicker Adapter… aber an welches Bauteil schließe ich die Kabel an?

  2. MaGn says:

    Hi,

    Sie haben mir sehr geholfen. Hatte via OTA geflasht, nur das Power Monitoring mit 287V hat mir Probs bereitet. Nun läufts. Danke

  3. Marko Junker says:

    Hallo, ohne es genau zu wissen, gehe ich mal davon aus, das die stl Datei für einen 3D-Druck vorgesehen ist. Macht nichts. Habe es gerne gespendet :=)) und vllt benötige ich es irgendwann nochmals.

    Danke für die Mühe den Adapter zu entwerfen und ihn der Community zur Verfügung zu stellen.
    Gruß ein gnulinuxer …

  4. ten Haaf says:

    Hallo und guten Abend!

    Leider habe ich keien 3D-Drucker und auch keine Kontakte, die über einen verfügen. Wären Sie bereit mir gegen eoine Aufwandspauschale einen Druck zukommen zu lassen?

    MFG
    Carsten

Leave a Reply

Your email address will not be published. Required fields are marked *